Regulate your battery charge and protect from overcharging with the 6A Charge Controller. It features 100% solid-state electronics. Rated 6A @ 12V or 24V.
This charge controller is compatible with sealed lead-acid, flooded lead-acid, gelled lead-acid, and absorbed glass mat (AGM) battery chemistries.
Pre-wired PowerFilm Connectors - Extremely High Reliability. Plug and Play with all PowerFilm solar chargers.
Extremely High Reliability
• Failure rate of less than 1 per 1,000 (<0.1%)
• 100% solid state. Power MOSFET design
• Manufactured in an ISO 9000 factory
• 100% pre-shipment functional testing
Longer Battery Life
• Advanced PWM charging
• Series design (not shunt) for cool operation
• 4-stage charging: bulk, absorption, float, equalize
• Optimized sealed or flooded battery set points
• Temperature compensated charging
• Low voltage load disconnect on several versions
Designed for Harsh Environments
• Temperature rating of –40°C to +60°C
• Epoxy encapsulation for protection against humidity and
dust ingress
• Corrosion protection: marine rated terminals and anodized
aluminum case
• Certified for use in hazardous locations
Easy to Install and Use
• Factory pre-sets result in no required install settings
• Electronic protections prevent damage from wiring mistakes
• Fully automatic operation and fault recovery
• LED’s display extensive information about status, faults and
battery condition
• 100% solid state
• Series design (not shunt)
• True 0 to 100% PWM duty cycle
• Setpoint accuracy 12V: +/-25mV; 24V: +/-48mV
• Fully encapsulated in epoxy potting
• Marine rated terminals / anodized case
• Temperature compensation
• Sealed / Flooded battery select